Samsung A8 (SM-A800F) Combination Firmware

SAMSUNG A800F Combination Firmware. Samsung combination firmware is factory binary service firmware that allow you to bypass FRP, this is the most purposes from this firmware for us. This Samsung combination is safe for update / flash because you can't downgrade Samsung OS version.

This Samsung combination firmware was used when the unit still at factory development and only for testing purposes. When you flash or update any Samsung with combination firmware, you should update again with official firmware because you can't use the phone normally.

The Combination firmware doesn't have aboot section because it will failed when you downgrade the version so, the combination doesn't contain aboot section.

Samsung A800F Combination Firmware Update Steps:
  1. You need to download Samsung Combination FirmwareSamsung Original FirmwareSamsung Driver and Samsung Odin
  2. Prepare all pre-requested file and software (install or extract them)
  3. Put your Samsung device in download mode by press volume up + home and power on
  4. Attach to PC and install driver (if needed) then open Odin software
  5. Load Combination firmware at PDA/AP tab and press "Start" button to update Samsung
  6. Wait until update finish and it should restarted after update finish
  7. Now you can use your phone at factory binary stage (you can enable USB debugging and factory reset)
  8. After all done, you need re-flash again with original firmware so, you can use phone normally

0 Response to "Samsung A8 (SM-A800F) Combination Firmware"

Post a Comment

Silahkan beri Komentar disini

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel