Samsung S8 and S8+ (SM-G95xx) Combination Firmware


Samsung S8 and S8 Plus Combination Firmware. Today i will share this Samsung combination firmware for FRP reset or FRP bypass Samsung S8. This is the fast way and easy to remove FRP Samsung S8 Plus. This already tested and hope it's also work for you.

As we know that when Samsung device updated using combination firmware, you need to flash or update it again using normal or official firmware for end-user. Always use latest combination firmware to avoid failed update.

Note:
  • Flash from normal firmware only system+sboot+boot+recovery+cache.
  • The phone need 15 min to boot up then only click next-next-next or swipe from up the notification bar and go to setting then to enable OEM and make hard reset. 
  • If your phone still boot hang on logo just re-flash sboot + boot from normal firmware.

Samsung S8 and S8 Plus Combination Firmware and Normal Firmware Update Steps:

  1. You need to download Samsung Combination FirmwareSamsung Original FirmwareSamsung Driverand Samsung Odin
  2. Prepare all pre-requested file and software (install or extract them)
  3. Put your Samsung device in download mode by press volume up + home and power on
  4. Attach to PC and install driver (if needed) then open Odin software
  5. Load Combination firmware at PDA/AP tab and press "Start" button to update Samsung
  6. Wait until update finish and it should restarted after update finish
  7. Now you can use your phone at factory binary stage (you can enable USB debugging and factory reset)
  8. After all done, you need re-flash again with original firmware so, you can use phone normally

0 Response to "Samsung S8 and S8+ (SM-G95xx) Combination Firmware"

Post a Comment

Silahkan beri Komentar disini

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel